Determine the necessary mass, volume, or concentration for preparing a solution.
active silicone polymer 100% for sensitive chromatographic and analytical workflows requiring minimal baseline interference.
Room temperature Ships Check lot-specific COA for exact specifications.
SDS, COA, datasheet, and spec sheet available for download. Lot-specific COA accessible via lot number lookup.
Cited in 0 peer-reviewed publications across chromatography, organic synthesis, and cross-coupling reactions.
Description:
ACP-0001 Antifoam Compound is a silicone foam control agent that is 100
percent active. Effective in both aqueous and nonaqueous systems, it can be used in
concentrations as low as one part per million. This antifoam compound is specifically
manufactured for industrial applications. Agitation of the product prior to use is required.
How to use:
Amount Needed
XIAMETER ACP-0001 Antifoam Compound is effective in very low concentrations. One to
100 parts antifoam per million parts foamer are sufficient to eliminate most foams. Begin
trials at higher use levels (50 ppm active silicone), then work down to the level of foam
control desired.
The following are parts per million equivalents:
3.34 ounces in 500 gallons = 50 ppm
6.67 ounces in 1,000 gallons = 50 ppm
16.68 ounces in 2,500 gallons = 50 ppm
5.0 quarts in 25,000 gallons = 50 ppm
Adding the Antifoam
To produce optimal foam control, it is necessary to have the antifoam completely dispersed
in the foaming medium. Follow these steps to achieve complete dispersion:
1. Agitate the product prior to use.
2. Predilute with 3 to 10 parts of a suitable low-viscosity diluent to aid dispersion. Add the
antifoam to the diluent with slow mixing. Prediluted material should be used immediately.
For solvent systems, XIAMETER ACP-0001 Antifoam Compound may be predispersed in
solvents such as kerosene, amyl acetate, 2-ethylhexanol, Stoddard solvent or toluene.
NOTE: When using any solvent, always provide adequate ventilation.
Follow precautions on solvent container label.
3. Add the antifoam prior to the point where foaming occurs within the system, if possible.
4. When used as supplied, the antifoam can also be wiped on filling nozzles, rims of
processing vats or on a screen suspended over the surface of a foaming system.
Comprehensive hazard, handling, storage, and regulatory compliance document.
Download SDS →Lot-specific quality data. Enter your lot number to retrieve the exact COA.
Look up COA →Full quality attributes and acceptance criteria for this grade.
View spec sheet →Find and download the COA for your product by matching the lot number on the packaging.
| Lot Number | Certificate Type | Data | Oggetto |
|---|---|---|---|
| Certificate of Analysis | Aug 07, 2023 | A466285 | |
| Certificate of Analysis | Aug 07, 2023 | A466285 | |
| Certificate of Analysis | Aug 07, 2023 | A466285 | |
| Certificate of Analysis | Aug 07, 2023 | A466285 | |
| Certificate of Analysis | Aug 07, 2023 | A466285 |