Tissue/Cell RNA Extraction Kit (One-Step Extraction Method)

Cat. No.: T1527583
Disponibile su ordine
QUALITÀ & PUREZZA BioReagent ? BioReagent grade — tested suitable for life-science and molecular-biology use. Use for cell culture, assays, and biochemical work needing biological compatibility.
★
Dimensione
Germania (EU)
USA*
Prezzo
Qtà
50T
T1527583-50T
Su ordinazione · 8–12 settimane
159,58€
Enter a quantity for the sizes you want to add.

Panoramica

RNA exists in diverse types and sources, and is isolated by various preparation methods, including the phenol method, detergent method and guanidine hydrochloride method. Among them, the phenol method is the most widely used. This RNA‑extraction reagent contains phenol, guanidinium isothiocyanate and other components. It rapidly lyses cells or tissues and inactivates nucleases to maintain RNA integrity. After adding chloroform and centrifugation, the solution separates into an upper aqueous phase (colorless), an interphase, and a lower organic phase (red). Total RNA is recovered by isopropanol precipitation from the upper aqueous phase; DNA is recovered by ethanol precipitation from the interphase; and proteins are recovered by isopropanol precipitation from the lower organic phase.

The Tissue & Cell RNA Extraction Kit (One‑step Extraction Method) is designed for rapid isolation of total RNA from various tissues or cells. It is compatible with both small‑scale samples (50‑100 mg tissue, 5×10⁶ cells) and large‑scale samples (>1 g tissue / >10⁷ cells). The extracted total RNA is of high quality and can be applied in Northern Blot, Dot Blot, polyA selection, in‑vitro translation, RNase protection assay and molecular cloning. This kit features: ① broad applicability; ② simple operation, with the whole procedure completed within 1 hour; ③ high purity; ④ low contamination. This kit is for research‑only purposes and shall not be used for clinical diagnosis or any other applications.

Component 

Storage Unit No.Storage Unit NameComponent No.Component NameAppearance50TStorage
T1527583NTTissue/Cell RNA Extraction Kit (One-Step Extraction Method)(RT Components)T1527583ARNA Separation SolutionLiquid10mlRoom temperature.Store in the dark.


T1527583BRNA Precipitation SolutionLiquid
50mlRoom temperature


T1527583CRNA Wash SolutionLiquid
50mlRoom temperature


T1527583DRNase-free ddH₂O
Liquid
10mlRoom temperature


T1527583ERNA Storage SolutionLiquid
10mlRoom temperature.Store in the dark.
T1527583WTTissue/Cell RNA Extraction Kit (One-Step Extraction Method)(2-8℃ Components)T1527583FRNA Extraction ReagentLiquid
50ml2-8℃.Store in the dark.

Note: Each component is individually packaged according to its storage temperature (Room temperature/2‑8 °C) upon shipment, with differentiated temperature‑controlled transportation to guarantee product performance. Orders containing materials requiring multiple temperature zones may be delivered in separate batches; please refer to the actual received goods. Upon receipt, store components separately at the temperatures specified in the component list. The shelf‑life is 12 months from the date of manufacture.
Note: Each component is individually packaged according to its storage temperature (Room temperature/2‑8 °C) upon shipment, with differentiated temperature‑controlled transportation to guarantee product performance. Orders containing materials requiring multiple temperature zones may be delivered in separate batches; please refer to the actual received goods. Upon receipt, store components separately at the temperatures specified in the component list. The shelf‑life is 12 months from the date of manufacture.

Operating Procedures

1.Sample Preparation

① Adherent cells: Direct lysis: Add RNA extraction reagent directly into the culture flask/dish to lyse cells at 1 mL per 10 cm² growth area, and mix thoroughly by pipetting.

Trypsin digestion: Wash cells with sterile PBS, then treat cells with PBS containing 0.05‑0.25% trypsin. After cells detach from the vessel surface, add serum‑supplemented medium to terminate the reaction. Transfer the cell suspension into an RNase‑free centrifuge tube, and follow the procedures for suspension cells below.

② Suspension cells: No cell washing is required. Centrifuge at 5000‑6000 g for 5 min to collect cell pellet and discard supernatant. Ensure complete removal of cell culture medium; incomplete removal will cause insufficient lysis and reduced RNA yield. Add 1 mL RNA extraction reagent per 5×10⁶‑10⁷ animal, plant or yeast cells, or per 10⁷ bacterial cells, and mix thoroughly by vortexing.

③Tissues: Use fresh animal/plant tissues or tissues stored at −70 °C. Fully grind 50‑100 mg tissue in liquid nitrogen, or grind with 1 mL RNA extraction reagent, or homogenize using a homogenizer. The sample volume should generally not exceed 10% of the volume of RNA extraction reagent. Complete grinding rapidly, ideally within 1 min.

④Blood: Take 0.5‑1 mL fresh or frozen blood. Centrifuge at 12000 g for 5 min and discard plasma. Add 1 mL RNA extraction reagent and mix thoroughly by vortexing.

2.Nucleic Acid Separation 

Vortex thoroughly. (Alternative: freeze‑thaw 1‑3 times by placing in low‑temperature / ultra‑low‑temperature freezer for 5‑10 min followed by thorough vortexing each time). Incubate the lysed sample or homogenate at room temperature for 5‑10 min to achieve complete dissociation of nucleoprotein and nucleic acids.

3. Sample Phase Separation

Add 0.2 mL RNA separation solution, vortex for 15 s, incubate at room temperature for 2‑3 min, then centrifuge at 12000 g, 4 °C for 10‑15 min. The upper layer is aqueous phase; the interphase and lower layer are organic phase. RNA resides in the upper aqueous phase.

4. RNA Precipitation

Transfer the upper aqueous phase (~500 μL) into an RNase‑free centrifuge tube. Do not aspirate any material from the interphase to avoid genomic DNA contamination. Add an equal volume of RNA precipitation solution and mix well. Incubate at room temperature for 15‑20 min. Centrifuge at 12000 g, 4 °C for 10 min. A gelatinous precipitate forms on the side or bottom of the tube; discard the supernatant.

5. RNA Washing

Add 1 mL RNA washing solution to gently wash the precipitate. Incubate at room temperature for 5‑10 min. Centrifuge at 7500 g, 4 °C for 5 min and discard supernatant. Air‑dry at room temperature for 5‑10 min. Avoid over‑drying, otherwise RNA will be difficult to dissolve.

6. RNA Dissolution

Add 30‑50 μL RNase‑free ddH₂O for full dissolution. Store long‑term at −70 °C or use directly in downstream experiments. For samples with high RNase content such as liver, pancreas and kidney tissues, dissolve the precipitate with RNA preservation solution.

Analysis and Quantitation

1. Determine RNA quality by measuring absorbance at 260 nm and 280 nm. Calculate RNA yield using the conversion factor: 1 OD = 40 μg/mL RNA. An OD₂₆₀/OD₂₈₀ ratio of 1.8‑2.0 indicates good RNA purity. Samples with concentration ≥4 μg/mL are suitable for spectrophotometric measurement.

2. Perform formaldehyde‑denaturing agarose gel electrophoresis to assess RNA integrity and contamination status.

3. Determine RNA quality and purity using a nucleic acid analyzer.

Troubleshooting

Common ProblemsPossible Causes
A₂₆₀/A₂₈₀ < 1.61. The RNA pellet obtained after extraction is not completely dissolved.
2. The aqueous phase is contaminated with organic phase, resulting in protein and DNA contamination.
3. RNA sample is dissolved in water instead of TE buffer (under low ionic strength and low pH, the A₂₈₀ value will be overestimated).
4. Too little total RNA extraction reagent is added during sample homogenization, so RNA is not completely separated from proteins and DNA.
5. After homogenization, the sample is not left at room temperature or the incubation time is too short, so RNA is not completely dissociated from nucleoproteins.
6. The sample contains tissue solvents (e.g., ethanol) or alkaline solutions, causing a reduction in the aqueous phase or an increase in pH.
DNA contamination1. The volume of reagent added during homogenization is too small (if DNA contamination exists, it can be removed with a DNA remover).
2. The aqueous phase is contaminated with organic phase, resulting in protein and DNA contamination.
Low RNA yield1. Sample lysis or homogenization is incomplete, so RNA is not fully released.
2. The obtained RNA pellet is not completely dissolved.
RNA degradation1. The extracted RNA contains RNase.
2. The tissue or cells are not fresh, and the sample is not promptly frozen in liquid nitrogen, leading to RNA degradation.
3. Solutions or centrifuge tubes are not treated to be RNase-free, and RNase contamination causes RNA degradation.
4. Cells are digested with trypsin for too long, causing partial RNA degradation even before the RNA extraction reagent is added.
5. The formamide used in electrophoresis has a pH lower than 3.5, causing acid hydrolysis of RNA.
Protein and polysaccharide contamination1. The aqueous phase is contaminated with organic phase, thereby carrying proteins and DNA.
2. The sample has high protein and polysaccharide content, or the sample amount is too large, so cells are not completely lysed.

Precautions

1. Sample storage: After mixing with RNA extraction reagent, samples can be stored at −70 °C for 1‑2 months. RNA samples can be stored in 70% ethanol at −70 °C for 2‑4 weeks. For long‑term storage, keep samples in an ultra‑low‑temperature freezer.

2. RNA extraction reagent and RNA separation solution contain corrosive substances. In case of skin or eye contact, immediately flush with clean water or normal saline, and seek medical assistance if necessary.

3. For personal safety and health, wear a lab coat and disposable gloves during operation.

4. Use reagents promptly after opening to avoid compromising downstream experimental results.

Specifiche

Sinonimi
Yeast RNA Extraction Kit
Specifiche e purezza
BioReagent
Grado
BioReagent
Sensibilità
Light Sensitive
Stoccaggio e spedizione
Condizioni di conservazione di stoccaggio
Store at 2-8°C,Protected from light,Room temperature
Spedito in
Normal,Wet ice
Stabilità e conservazione
Each component has a shelf life of 12 months under corresponding storage conditions.
Contents & Storage
Storage Unit No.Storage Unit NameComponent No.Component NameAppearance50TStorage
T1527583NTTissue/Cell RNA Extraction Kit (One-Step Extraction Method)(RT Components)T1527583ARNA Separation SolutionLiquid10mlRoom temperature.Store in the dark.
T1527583BRNA Precipitation SolutionLiquid
50mlRoom temperature
T1527583CRNA Wash SolutionLiquid
50mlRoom temperature
T1527583DRNase-free ddH₂O
Liquid
10mlRoom temperature
T1527583ERNA Storage SolutionLiquid
10mlRoom temperature.Store in the dark.
T1527583WTTissue/Cell RNA Extraction Kit (One-Step Extraction Method)(2-8℃ Components)T1527583FRNA Extraction ReagentLiquid
50ml2-8℃.Store in the dark.

Note: Each component is individually packaged according to its storage temperature (Room temperature/2‑8 °C) upon shipment, with differentiated temperature‑controlled transportation to guarantee product performance. Orders containing materials requiring multiple temperature zones may be delivered in separate batches; please refer to the actual received goods. Upon receipt, store components separately at the temperatures specified in the component list. The shelf‑life is 12 months from the date of manufacture.


Dati avanzati

Certificati (CoA, COO, BSE/TSE e tabella di analisi)
C of A & Other Certificates(BSE/TSE, COO):
Analytical Chart:
Domande frequenti e articoli
Calcolatori di soluzioni
Recensioni

Recensioni dei clienti

Domande frequenti

How is this product shipped?
This product ships under standard ambient conditions. No temperature-controlled packaging is required.

Desidera che le inviamo un messaggio quando avremo sconti disponibili?

Ricordamelo più tardi

Grazie! Controlli la sua casella di posta per confermare.

Ops! Le notifiche sono disabilitate.