Plank-Rychlo Decalcifying Solution - BioReagent, Ready-to-use

Cat. No.: P1529299
Disponível para encomenda
GRAU & PUREZA BioReagent ? BioReagent grade — tested suitable for life-science and molecular-biology use. Use for cell culture, assays, and biochemical work needing biological compatibility. Ready-to-use ? Ready-to-use — supplied pre-formulated at working concentration, no prep needed. Use to save time and reduce pipetting/dilution errors.
Storage
Room temperature
Shipped In
Normal
Application
952
★
Tamanho
USA
Alemanha (EU)*
Preço
Qtd
100ml
P1529299-100ml
Sob encomenda · 8–12 semanas
19,90US$
500ml
P1529299-500ml
Sob encomenda · 8–12 semanas
59,90US$
Enter a quantity for the sizes you want to add.

Visão geral

During tissue sectioning, tissues containing bone or calcified lesions cannot be directly embedded in paraffin for sectioning. Due to the density difference between calcium and paraffin, intact sections are difficult to obtain. For calcium‑containing tissues, decalcification should be performed after fixation, or fixation and decalcification can be carried out simultaneously, followed by downstream procedures including dehydration, clearing, wax infiltration, embedding and sectioning. A wide range of decalcifying agents are available, such as organic acids, inorganic acids, ethylenediaminetetraacetic acid (EDTA), and electrolytic decalcification.


Plank‑Rychlo Decalcifying Solution is mainly composed of dilute acid, ammonium chloride or aluminium chloride, formic acid and other components. Its advantages are as follows:

① Fast‑acting, with shorter processing time than JYBL‑Ⅰ (Aladdin Cat.No.: J1525466), generally complete within 24 h;

② Low damage to tissue structure;

③ Thorough decalcification.

This decalcifying solution is especially suitable for routine decalcification of bone specimens in pathology laboratories. However, chemical methods are not recommended for determining the decalcification endpoint, and it may cause certain damage to tissue architecture.

This reagent is for research use only and is not intended for clinical diagnosis or other applications.

Materials to be prepared

1. Distilled water or PBS

2. Heating device or microwave oven, dedicated glass container for decalcification 

Operating Procedures (For Reference Only)

1. For bone‑tissue decalcification, samples should not be excessively thick; the recommended thickness is approximately 3‑5 mm.

2. After tissue fixation, rinse samples 3 times with distilled water or PBS, 20 min each time.

3. Transfer tissues into Plank‑Rychlo Decalcifying Solution at 20‑30‑fold volume and decalcify for 24 h. To accelerate decalcification, incubate at 37 ℃.

4. Rinse several times with distilled water.

5. Proceed with standard dehydration and embedding.

Precautions

1. Bone tissues shall be fully fixed prior to decalcification, and tissue blocks should be kept as small as possible.

2. Bone tissues should be decalcified after fixation, or fixation and decalcification shall be performed concurrently. Decalcification prior to fixation is not allowed to minimize tissue damage.

3. For 5 mm‑thick bone blocks, decalcification usually takes 24‑36 h.

4. Moderate heating accelerates decalcification; temperature should generally not exceed 37‑40 ℃. Excessively high temperature may cause bone tissue disintegration, and the temperature must never exceed 60 ℃.

5. Check the decalcification progress periodically. Complete decalcification is required to avoid under‑decalcification or over‑decalcification. Over‑decalcification aggravates tissue damage and compromises staining results. Decalcification should be sufficient for sectioning while keeping the processing time as short as possible.

6. Avoid metal containers for decalcification procedures.

7. Thoroughly rinse specimens with tap water upon completion of decalcification to prevent interference with staining.

8. Wear a lab coat and disposable gloves for your safety and health during operation.

Appendix

Determination of Decalcification Endpoint (Physical Method):

Use needle piercing, pinching or forceps clamping. Terminate decalcification when bone tissue softens or no resistance is felt during needle piercing. Physical detection may cause certain damage to tissue structure; avoid excessive force and repeated testing.

Especificações

Especificações e pureza
BioReagent, Ready-to-use
Estabilidade e armazenamento
Store at RT long term (12 months).
Condições de armazenamento de armazenamento
Room temperature
Enviado em
Normal
Grau
BioReagent, Pronto a usar
Product Line
Produtos biológicos
Nomes e identificadores
PH
7.4

Dados avançados

Certificados(CoA,COO,BSE/TSE e Mapa de Análise)
C of A & Other Certificates(BSE/TSE, COO):
Analytical Chart:
Calculadoras de soluções
Revisões

Avaliações dos Clientes

Precisa de ajuda para escolher o grau?

O nosso guia de seleção de graus abrange pureza, estado do estabilizador e adequação à aplicação para todas as variantes do nosso catálogo.

Ver o guia de graus BioReagent → Ver o guia de graus Ready-to-use →

Deseja que lhe enviemos uma mensagem quando tivermos descontos disponíveis?

Lembrar-me mais tarde

Obrigado! Por favor, verifique a sua caixa de entrada de e-mail para confirmar.

Ops! As notificações estão desativadas.