Determine the necessary mass, volume, or concentration for preparing a solution.
Nichrome etchant is a high purity etching system that is a mixture of ceric ammonium nitrate and nitric acid. It can be used to etch the nickel and chromium alloy.Ceric ammonium nitrate-based etchant. Etches Al, Cr, Cu, Ni, GaAs. Surface oxidizes Si, Ta/TaN. Etch rate of 50 Å/sec @ 40 °C. Etches cleanly with only a deionized water rinse needed.Nichrome etchant is used in the fabrication of microheater patterns of polydimethyl siloxane (PDMS), silica (SiO2) and glass substrates, which can be further used in the fabrication of flow sensors. It may also be used to etch out nickel (Ni) from the electroplated Ni on amorphous silica wafers.For use at room temperature or elevated temperature. Etches cleanly, eliminating need for an intermediate rinse.
H272:May intensify fire; oxidizer
H290:May be corrosive to metals
H314:Causes severe skin burns and eye damage
H317:May cause an allergic skin reaction
H411:Toxic to aquatic life with long lasting effects
P210:Keep away from heat, hot surface, sparks, open flames and other ignition sources. - No smoking.
P220:Keep away from clothing and other combustible materials.
P273:Avoid release to the environment.
P280:Wear protective gloves/protective clothing/eye protection/face protection.
P391:Collect spillage.
P303+P361+P353:IF ON SKIN (or hair): Take off Immediately all contaminated clothing. Rinse SKIN with water [or shower].
P370+P378:In case of fire: Use ... to extinguish.
P304+P340+P310:IF INHALED: Remove person to fresh air and keep comfortable for breathing. Immediately call a POISON CENTER/ doctor.
P305+P351+P338+P310:IF IN EYES: Rinse cautiously with water for several minutes. If contact lenses are worn and can be easily removed, remove Contact lenses. Continue rinsing. Immediately call an emergency center/doctor.